QOS Configuration Guide

QOS Configuration Guide

VOIP Setup




Configuring VOIP during QOS setup





QOS Classes




Creating a QOS Rule


Pre-Configured Traffic Types (Zoom, RDP, Dialpad, Webex)


Set Priority to Traffic Type



Assign Security Group (VLAN)


Creating a Custom QOS Class


Examples





Setting Bandwidth Limits for each Class



Setting General Data Bandwidth Limits on VOIP Tab



Support

Support Line: 971-317-3001

    • Related Articles

    • Best Practices for Managing Client Networks

      Network Security and Equipment Protection Best Practices Overview This document outlines critical best practices for securing network assets and protecting equipment when managing client networks. Following these guidelines helps ensure network ...

    • Speedtest results are slower than expected

      Unlike cable internet, which connects several DOCSIS 3.x channels to generate a 1 Gb/s link, fiber internet has a considerably smaller number of bonded channels. Even with that, increasing the number of test streams has a substantial influence on ...

    • Country Blocking - Configuration, Bad Actors List

      Setup: Country Blocking is in your Portal > Firewall > Countries United States and Canada Only NOTE: We do not recommend setting Rule: Accept traffic from United States / Canada. In this configuration your clients will not be able to use services ...

    • WAN Mapping - Multiple Static IPs

      Introduction This article describes the configuration, and mapping usage, when multiple Static IPs are added to the Primary or AUX WAN Ports. WAN Static IP Capabilities: Up to 4 Static IPs may be configured for each of the WAN Ports. Each Static IP ...

    • Export a human readable Sonicwall Configuration File

      For exporting a human-readable config from a Sonicwall device, the Sonicwall forum recommends getting into the CLI and doing: cli screen length session 2600 cli screen width session 128 show tech-support-report Please send the output to Uplevel ...