Surveying Wifi / AP layout

Surveying Wifi / AP layout

The number of APs per location depends on the square footage as well as the structure of the building. For a normal single-level office layout with drywall and wood, we typically recommend 1 AP for a max of about 2000 sq. ft, or 25 devices, whichever is lower. For a building that uses masonry or has multiple levels, the number of APs would increase to provide adequate coverage. Unfortunately the nature of Wi-Fi is that it's impossible to predict exactly how many APs will be required without a site survey, which is rather time-consuming. However, we've worked with partners in the past to provide guidance and recommendations that have (for the most part) been fairly good.

The optimal separation between APs for an open-plan office with drywall is usually about 20-30 feet between APs, but again this depends on the density of client devices and the material of the walls. Sometimes we've suggested using outdoor APs inside large offices or warehouses because our outdoor APs are more powerful and have high gain antennas.

    • Related Articles

    • Remove an AP (Access Point) from a Customers Portal

      This article describes how to remove an AP from your Customer's site in the Portal. If you require support due to an alert that a "Wi-Fi AP unplugged or not working", please see this support article. If you disconnect or relocate an AP you will see a ...

    • High Gain Wifi Antenna for Outdoor APs - 3rd Party

      When having to cover long distances with our Outdoor Access Points, we recommend using the Ubiquit airMax high gain antennas. They connect right up and have extended our APs range to over 600ft - ...

    • Moving Switches or APs

      You can move Uplevel Switches and APs at will between customer sites. However, the system will alert you to the fact that the Switch or AP is missing from the customer site until you remove it from the last customer's site in the Portal - that is, ...

    • Site to Site VPN (Uplevel to Uplevel)

      Introduction Configuring site-to-site VPNs between Uplevel Gateways is done with a single click. In addition, routing, switching, firewalling, VLANs are all configured automatically to ensure security with maximum convenience. Configuration From your ...

    • UAP-101 Mounting Diagram - Wifi5 Indoor APs

      Mounting the UAP-101 Please verify contents of the box before continuing to set up the UAP-101. UAP-101 Access Point 12V/2A 100V~240V Power Adaptor RJ-45 Ethernet Cable Mounting Bracket Wall/Ceiling Mounting Hardware Kit T-Rail Mounting Hardware Kit ...