Pre-Deployment Checklist
Pre-Deployment Checklist
A Deployment Checklist is attached to this article and should be completed for each new client.
This ensures that you have all of the necessary Static IPs, VPN Accounts, and other configurations to either pre-setup your client's new Gateway or rapidly configure when you get on site.
This ensures that you have all of the necessary Static IPs, VPN Accounts, and other configurations to either pre-setup your client's new Gateway or rapidly configure when you get on site.
Before going onsite, you will want to connect the Gateway to any switch port that will give it a DHCP address and internet access. This will save you 15-20 minutes if the Gateway requires a Firmware Update, and also could save you hours if the Gateway was not online during it's last certificate update and requires intervention from Uplevel Support before the Gateway will come online.
Before going onsite, you will want to connect the Gateway to any switch port that will give it a DHCP address and internet access. This will save you 15-20 minutes if the Gateway requires a Firmware Update, and also could save you hours if the Gateway was not online during it's last certificate update and requires intervention from Uplevel Support before the Gateway will come online.
Download the excel spreadsheet below:
Related Articles
Accessories That May Be Needed At An Install
Cat6 Ethernet Cable Complete cables with RJ45 connectors 5' Cables 25' Cables 50' Cables Bulk RJ45 Connectors 250' Spool Indoor Cat6 19" Rackmount Shelves 19"x7" Shelf 19"x8" Cantilevered Shelf RJ45 > USB Serial Console Cable 6' Cable Surge ...Best Practices for Managing Client Networks
Network Security and Equipment Protection Best Practices Overview This document outlines critical best practices for securing network assets and protecting equipment when managing client networks. Following these guidelines helps ensure network ...Point to Point (P2P) Wireless Bridge Setup Guide
Point to Point (P2P) Wireless Bridge Setup Guide Overview This guide walks you through setting up a wireless point-to-point bridge to extend your network to a remote location. The bridge consists of two wireless devices: an upstream device connected ...QOS Configuration Guide
VOIP Setup Configuring VOIP during QOS setup QOS Classes Creating a QOS Rule Pre-Configured Traffic Types (Zoom, RDP, Dialpad, Webex) Set Priority to Traffic Type Assign Security Group (VLAN) Creating a Custom QOS Class Examples Setting Bandwidth ...CIS Level 1 and 2
Introduction The Center for Internet Security (CIS) benchmarks are a method of specifying a secure baseline configuration for assets. This includes assets of all kinds: servers, workstations, network devices, firewalls, phone systems, etc. ...