Power Consumption Data Sheet

Power Consumption Data Sheet

UG-101 gateway: 36W
UAP-101 indoor AP: 24W max (but typical consumption is 7W or less)
UAP-102 outdoor AP: 24W max (typical consumption is 10W or less)
24-port PoE switch: max draw 410W
48-port PoE switch: max draw 410W

Note:  The manufacturer does not separately specify the base power draw of the 24-port and 48-port switches. As a rough estimate, about 50W for the 24-port switch and 75W for the 48-port switch can be used for the power draw with no PoE devices connected.



    • Related Articles

    • Data Transfer Rates 1xx vs 206 Gateways.

      The Engineering Department completed their performance comparison of the UG-206 and UG-101. Here is the summary. They ran his tests using two different sets of data, both 20GB in size. The first set was 20 files of 1GB each. The second set was 20,000 ...

    • UG-206 and UG-208 Tech Spec Sheet

           

    • WAN Mapping - Multiple Static IPs

      Introduction This article describes the configuration, and mapping usage, when multiple Static IPs are added to the Primary or AUX WAN Ports. WAN Static IP Capabilities: Up to 4 Static IPs may be configured for each of the WAN Ports. Each Static IP ...

    • Using LTE / Mobile Network Modem As Primary or Backup / Failover Connections

      Choosing Hardware: Since the Uplevel Unbox provides Wi-Fi and firewall capabilities, we recommend using a single-purpose modem, which simplifies configuration and reduces the solution cost. In this document, for our examples we use the Netgear 4G LTE ...

    • Setting Static IPs on the WAN Ports

      From the Uplevel Portal (Firmware Version 4.4+) Login to your Portal and navigate to the Overview section for the Site you would like to configure Click Set WAN Static IP Select Static IP from the drop down menu Enter the IP Address, Gateway Address, ...