LAN Subnet and DHCP Server Configuration

Manage the DHCP Sever on on the Uplevel Gateway 

Map Mac Addresses to IP Addresses in the DHCP Pool

• Related Articles

• WAN Mapping - Multiple Static IPs

  Introduction This article describes the configuration, and mapping usage, when multiple Static IPs are added to the Primary or AUX WAN Ports. WAN Static IP Capabilities: Up to 4 Static IPs may be configured for each of the WAN Ports. Each Static IP ...

• Setting Static IPs on the WAN Ports

  From the Uplevel Portal (Firmware Version 4.4+) Login to your Portal and navigate to the Overview section for the Site you would like to configure Click Set WAN Static IP Select Static IP from the drop down menu Enter the IP Address, Gateway Address, ...

• Create allowlists and blocklists using MAC Addresses

  Create allowlists or blocklists using MAC Addresses. You can create an allowlist or blocklist per VLAN with a hosts MAC Address. From the Portal > Devices page choose Mac Filter on the top right of the page: Enter the MAC Address, the VLAN the host ...

• Creating Shares and Mapping Windows Network Drives

  Note: These instructions are for a Non-Domain Services (Active Directory) environment. If using the Uplevel Directory Service, drive mapping is automatically done with GPOs on login. Mapped Drives are set at Uplevel Portal > Directory > Mapped Drives ...

• Hostnames not showing in the Portal > Devices section

  This pertains to using Static IPs. If you are using DHCP, please open a support ticket. The Static IP hostnames on the Portal > Devices page are a bit, for lack of a better word, dicey. We can retrieve and save hostnames to the hostname field if the ...