Create allowlists and blocklists using MAC Addresses

Create allowlists and blocklists using MAC Addresses

Create allowlists or blocklists using MAC Addresses.

You can create an allowlist or blocklist per VLAN with a hosts MAC Address. 

From the Portal > Devices page choose Mac Filter on the top right of the page:



Enter the MAC Address, the VLAN the host is on, and choose to create an Allow or Block list:



To create the list press OK

    • Related Articles

    • Country Blocking - Configuration, Bad Actors List

      Setup: Country Blocking is in your Portal > Firewall > Countries United States and Canada Only NOTE: We do not recommend setting Rule: Accept traffic from United States / Canada. In this configuration your clients will not be able to use services ...

    • LAN Subnet and DHCP Server Configuration

      Manage the DHCP Sever on on the Uplevel Gateway Map Mac Addresses to IP Addresses in the DHCP Pool

    • Using LTE / Mobile Network Modem As Primary or Backup / Failover Connections

      Choosing Hardware: Since the Uplevel Unbox provides Wi-Fi and firewall capabilities, we recommend using a single-purpose modem, which simplifies configuration and reduces the solution cost. In this document, for our examples we use the Netgear 4G LTE ...

    • Creating Accounts in the Uplevel Portal

      Types of accounts In your Profile > Settings > Other Accounts tab you can create two types of accounts: Admin - Can create new accounts Tech - Can not create new accounts Create accounts Profile > Settings > Other Accounts tab

    • Connecting Uplevel Switches using SFP Ports

      Tested SFP Modules: TP-LINK Gigabit SFP module, 1000Base-SX Multi-mode Fiber Mini GBIC Module, Plug and Play, LC/UPC interface, Up to 550/220m distance (TL-SM311LM) Connecting and Chaining Switches "SFP1", "Uplink SFP" should be connected to an ...